Graphene Reptile Heat Mat — 37°C Constant Temperature

Graphene Reptile Heat Mat — Under Tank Heater for Terrariums

Give your reptile or amphibian a comfortable warm zone with a full-surface graphene heat mat designed for stable, even under-tank warmth. The thin, low-watt design helps create a reliable basking/warm area without bright light, making it ideal for many terrarium setups where consistent belly heat is preferred.

Built with sealed edges and an easy-wipe surface, it’s made for everyday enclosure care—perfect for terrariums, breeding tubs, and warm-zone support in reptile rooms.

Why you’ll love it

• Uniform, full-surface heating: Helps reduce “hot spot” risk compared with uneven heat sources by spreading warmth across the mat.

• Low-watt, energy-saving options: Choose a size and wattage that fits your enclosure and heating plan.

• Quiet, light-free warmth: Supports natural day/night cycles when used alongside proper lighting.

• Sealed edges + wipe-clean surface: Easier routine cleaning for reptile keepers and breeders (do not immerse).

• Built for under-tank use: A common, efficient method for providing heat to reptile/amphibian enclosures when installed correctly.

Recommended uses

• Terrariums and vivariums (warm zone support)

• Breeding tubs / rack systems (warm side heating)

• Reptiles & amphibians that benefit from belly heat (species needs vary—always research husbandry requirements)

Setup tips (best practice for US/EU keepers)

To keep reptiles healthy, you generally want a warm zone + cool zone (a temperature gradient) rather than heating the entire enclosure evenly.
Most keepers achieve this by placing an under-tank heat mat on one side of the enclosure (often around one-third of the floor area).
For safe, consistent control, many reptile care guides recommend using a thermostat and correctly placing the probe for under-tank heating, then verifying surface temps with a thermometer/IR temp gun.

Care & safety (add this near the bottom of the page)

• External use only: Install the mat on the outside bottom of the enclosure (under the tank), following common under-tank heater installation guidance.

• Use a thermostat for control: A thermostat helps regulate heat output; probe placement matters, and you should confirm actual surface temps inside the enclosure.

• Create a gradient: Heat only part of the enclosure so your animal can self-regulate by moving between zones.

• Do not immerse: Wipe clean only; keep electrical components dry. (Use “wipe-clean / water-resistant” wording rather than “washable”.)